1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 101Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 101

Thermomelt Stik Procedure 1Install correct test propeller and place engine in test tank 1 To avoid accidental starting of
for causes of overheating Servicing Camshaft Seal The presence of oil under the cam pulley could indicate leaking camshaft
sealThe seal can be replaced without disassembly of cylinder headRemove the belt, cam pulley, and key as described in this
sectionUse OMC Seal Remover Kit, PIN 391060, and OMC Pressing Screw, PIN 342227, to remove the seal To remove seal, install
tip "A" into removerinstaller bodyThread removerinstaller body with tip into seal to engage metal caseWhile holding removerinstaller
body, turn pressing screw and remove seal To install new seal, apply OMC Gasket Sealing Compound to the outside diameter
of the metal casing Position seal on cylinder head with casing facing up INote When starting seal over the cam, be sure he