1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 113Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 113

[]][8Use ONIC Valve Spring Compressor, PIN 341446, to facilitate removal of valves and componentsPosition compressor end
1Remove any carbon accumulation from cylinder head combustion chambers2If cylinder walls are glazed from extended use, use
medium grit hone to resurface wallsUse slow RPM to achieve strong "crosshatch" pattern for best oil retention and ring sealing
To avoid personal injury, wear eye protection and rubber gloves when using ONIC Gel Seal and Gasket Remover 3Use ONIC Gel
Seal and Gasket Remover to remove all traces of gaskets and adhesives from the cylinder block and crankcase4Carefully remove
any carbon accumulation from the tops and ring grooves of the pistonA ring groove cleaning tool can be made by breaking an
old ring and grinding an angle on its end Do not damage ring grooves while cleaning5Thoroughly wash entire cylinder block