1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 120Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 120

5To install oil control ring assembly, place segmented ring in bottom groove firstInsert the end of first scraper ring under
piston ring placement [[J INote 8 Scraper Ring Gaps Middle Compression Ring Gap Segmented Ring Gap Top Compression Ring Gap
9Lubricate the cylinder walls with oilLubricate the inside surface of an expandable piston ring compressor and place the
piston and rod assembly inside Be sure the piston rings are at the prescribed angles per [] 10Place the ring compressor with
piston and rod on the cylinder block, and align with cylinder boreThe stamped arrow on the piston crown faces the flywheel
endRap piston into bore with wood hammer handle end or equivalent 11If removed, install new crankshaft sleeve with O-ring
on end of crankshaft using OIVIC Crankshaft Sleeve Installer, PI 342210, until seated Apply OIVIC Moly Lube to the O-ring