1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 124Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 124

5Install OMC Crankshaft Pulley Nut Removerlnstaller, PI 342212, on crankshaft taper aligned with keyway and secure in place
Nm)2Rotate crankshaft pulley clockwise one revolution (360)This will rotate camshaft pulley one-half revolution (180) so
the pointer faces opposite the extrusion on the manual starter boss3Set tappets for No1 piston in same fashion to the same
specifications as No.2 piston[] 4Place new valve cover seal in the valve coverPosition cover, with bracket, on the cylinder
head and apply OMC Gasket Sealing Compound to the screwsTorque to 84-106 inIbs(10-12 Nm) in stages in the sequence shown]5Apply
OMC Pipe Sealant to the oil pressure switch and torque to 120-168 inIbs(13,5-19 Nm)Apply oil to oil filter seal and install
filterTighten one-fourth turn after seal contacts block[] 6Install fill plug and dipstick 7If equipped, install exhaust probe