1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 158Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 158

13Remove the pinion, two thrust washers, and thrust bearing rn 14Remove the shift rod bushing as follows: Position CWK: Shift
bushing for damageIf damaged, replace the bushing on reassemblyRemove and discard the a-ring from the bushing 15Using OMC
Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131, remove the two driveshaft sealsDiscard the seals NoteInspect
bearings for damage while in placeIf bearing is damaged, remove and discardIf the bearing is removed for any reason, it must
be replaced 16Using OMC Puller Bridge, PIN 432127, and CWK: Small Puller Jaws, PIN 432131, remove the bearing and sleeve