1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 161Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 161

Assembly INote Make no dry assemblies Lubricate bearings, shafts, and gear with OMC Ultra-HPF gearcase lube 1Oil the small
the outer seal onto the tool with lip facing the toolApply OMC Gasket Sealing Compound to the metal casing of the sealsInstall
the seals into the housing until the tool is seatedApply OMC Triple-Guard grease to the seal lips after installing4Apply
OMC Triple-Guard grease to new bearing housing a-ringPlace the a-ring in the bearing housing groove rn 5To install thefrom
the holding fixture, into placegearcase, forward bearing cup the and the nose remove the gearcase of it on wooden blockDrive
in the bearing cup with mallet and OMC Bearing Cup Installer, PIN 319929, attached to OMC Drive Handle, PIN 311880 4-CYCLEeng