1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 162Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 162

6Install the pinion bearings using the following components of ONK: Universal Pinion Bearing Remover and Installer, PIN 391257,
washer contacts long spacer OJ INote To ensure accurate bearing location, washer must be flat and screw must be tight 7Using
ONK: Bearing Installer, PIN 319931, and an arbor press, install the driveshaft bearing into the bearing sleeve with the lettered
side against the tool8Oil the bearing sleeve and install with the bearing into the gearcase using ONK: Bearing Installer,
PIN 319931Keep the lettered side of the bearing against the tool9Using ONK: Seal Installer, PIN 326554, install two new driveshaft
seals back to back as follows: Apply ONK: Gasket Sealing Compound to the metal casing of the seals before installing Install