1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 165Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 165

25Apply ONIC Gasket Sealing Compound to the threads of the bearing housing screwsInstall the screws and tighten to 60-84
repairs and repeat test Screw in vacuum testerPump out to 3-5 inof mercury and see if vacuum holdsThen pump out to 15 inof
mercury and checkIf the gearcase fails to hold on either test, put oil around suspected sealIf leak then stops or oil is
drawn in, that seal is defectiveWhen the gearcase checks out OK, refill with ONIC Ultra-HPF gearcase lubricant[] 28Fill the
gearcase with 8-9 floz(230-260 ml) lubricant as follows: Secure the gearcase in an upright position Remove the oil level
and the oil filldrain plugsReplace the seals Fill the gearcase with CWIC Ultra-HPF gearcase lube until lubricant appears
at the oil level holeInsert the oil level plug firstInstall the filldrain plugTighten the oil level and the filldrain plugs
to 84-86 inIbs(9-10 Nm) Inspect the gearcase oil level after motor test has been performed29Inspect water pump as described