1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 205Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 205

[] 2Remove the positive connection (red) for the battery cable and engine wiring harness at the solenoid 3Remove the yellowred
and install screws securely 3Position starter and torque screws to 18 ftIbs(25-27 Nm)Install cable from solenoid and torque
nut to 60-84 inIbs(7-9 Nm)Apply ONK: Black Neoprene Dip to cable connection rn 4Connect the two Amphenol and three bullet
connectorsW 5Attach wire to pressure switch Install the yellowred and black wires and torque nuts to 12-24 inIbs(1,4-2,8
Nm)Apply ONK: Black Neoprene Dip at wire connections[] 6Attach the positive connection (red) for the battery cable and engine
wiring harness at the solenoidTorque nut to 60-84 inIbs(7-9 Nm)Apply ONK: Black Neoprene Dip at connection rn engine wiring
ground connection (black) for the battery 60-84 7Attach the cable and harness at the powerheadTorque nut to inIbs(7-9 Nm)Apply