1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 54Get this manual

1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 54

[[] 8Temporarily install cable retainer and screw 9Check cable adjustment Ifthrottle cable adjustment is too loose, idle
the shift cable to the shift lever using the pin and cotter clipas shown[] 5Rotate the propeller shaft and shift the gearcase
into FORWARD6Move the remote control handle to full throttle in FORWARD7Apply liberal amount of OMC Triple-Guard grease to
anchor block pocket 8Pull firmly on cable casing to remove backlash and adjust cable trunnion nut to locate in anchor pocket9Temporarily
install the anchor pocket cover and screw 10Shift the remote control to NEUTRAL INote If the gearcase has been serviced,
verify the powerhead neutral detent adjustmentRefer to Installation, Section 611The neutral detent must be in NEUTRAL (center
position) when the control lever is in NEUTRAL 12Remove the shift cable from anchor pocket and verify that the gearcase is