1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 55Get this manual

1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 55

INote If there are not enough threads on the shift cable to allow the adjustment in Step 12, or if the gearcase detent does
(sparks) or from contact with moving parts if accidental cranking or starting occursProvide sufficient slack at motor end
to permit steering and tilting of motor without binding cables 1Reposition fuel manifold to make room for the routing of
electrical cables 2Remove fuel connector bracket and lay to the side of the lower engine cover rn 3Route will not interfere
with the upper motor cover when instrument harness into lower motor coverPosition harness so it installedRoute instrument
harness to position where the connectors can be attached at the junction box rn 4Install connector on non-trim modelsengine)
on power protective plug (supplied with trimtilt 3-pin [] 5Before installing connections, check that the seal is in placeClean
off any dirt from connectorsApply light coat of ClVIC Electrical Grease to the sealPush connectors together until latched