1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 82Get this manual

1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 82

6Test the "NO OIL" warning circuit: Connect shop tank with 50fueloil mix to the fuel inlet fitting Remove the protective
might be in the line Install the oil hose on the oil inlet fittingUse only the ratchet clamp supplied with the kit to secure
the lineTighten with pliers To complete priming, squeeze oil primer bulb until oil is visible atthe sight tube located in
the oil hose near the pump During the break-in period, the engine's fuel tank must have 50:1 fueloil mixture in addition
to operation I Note Prime the oil system before priming fuel system If fuel system is primed first, the oil system must be
primed with the engine idlingPrime until oil is visible at the sight tubeWarning horn will sound until oil reaches the pump8Store
the protective cap removed from the oil inlet fitting on the yellow cap holder attached to the VRO fuel hose9The oil level
must be marked on the side of the reservoir before putting the engine into service After the break-in period, the operator
must verify that oil has been used before switching to clear fuel in the boat's fuel tank10Follow Engine Break-In Procedure