1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 95Get this manual

1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 95

8Check for correct positioning of float levelFloat level controls the height of fuel in the float chamber and is very critical
to dimension shownTo adjust, bend tab on float arm where tab contacts float seat r:J5l Base of Carburetor Body Bend Float
Lever Tang to achieve proper dimension CD in to 158 in(28-41 mm) 10Install float chamber and new gasket11Apply OMC Locquic
Primer and OMC Screw Lock to the threads of four float chamber screwsInstall the screws and torque in an "X" pattern to 25-35
inIbs(2,8-4,0 Nm)Installation INotel Do not use sealer on carburetor gaskets& Replace any fuel hoses if deteriorated or damaged
1Install new carburetor flange gaskets2Install primer hoses to carburetor nipples3Install carburetors on manifold studs,
and secure with lock washers and nuts4Install fuel hoses on carburetors, and secure, using new clamp and OMCTie Strap Installation