1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 99Get this manual

1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 99

Assembly 1Place leaf valves on leaf plateIf new valves do not seat on the leaf plate, turn the leaf valves over r::=J Used
near center of leaf stopDo not tighten1254 161 6Hold leaf valve assembly in horizontal positionThis will usually align leaf
valves over ports in leaf plateTighten the two screws evenly (2] 7Use sharp pencil to mark the edges of leaf valves'8l 8Use
pencil eraser to gently open the leaf valves to check the alignment of the valve over the portValves should be spaced evenly
over portIf not, loosen mounting screws and reposition leaf valve9After leaf valve is positioned properly, install remaining
screwsTighten all screws evenly to torque of 25-35 inIbs(3-4 Nm)10Apply OMC Locquic Primer and OMC Nut Lockto the leaf plate
assembly to manifold screws11Using new gaskets installed dry, position each leaf plate assembly and torque the screws to