1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 196Get this manual

1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 196

Install the steering friction thrust ringbevel side up in the swivel bracketThread the steering friction screw in the swivel
thrust washer in the lower mount bracketSlide the lower mount bracket on the splines of the pivot shaft while aligning front
of the mount bracket with the steering armInstall the retaining ring on the pivot shaft with sharp edge of ring facing out
13Lubricate the swivel bracket through the four lubrication fittings with OMC Triple-Guard grease36 14Slide the steering
arm seal onto the steering arm with the word "TOP" facing up r::;;l 15Position the upper rubber mount, the upper mount washersand
the retaining washers on the steering arm with the word "UP" on the mount facing upBe sure to place the ground lead between
the mount (starboard side) and the steering armInstall and tighten the mount retaining screws to torque of 24-26 ftIbs(32-35