1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 229Get this manual

1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 229

Propeller Shaft Bearing Housing Service 1Remove seal(s) using 0Nk: Puller Bridge, PIN 432127, and OW; Large Puller Jaws,
housing retaining screws in solventDiscard the retaining screw O-rings6Inspect the bearing housing anodeReplace anode if
it has been reduced to two-thirds its original size (one-third eroded) 12911301 7Oil, then install new bearings in the bearing
housing using 0Nk: Bearing Installer, PIN 326562 Press against the lettered side of the bearing to prevent damage to the
bearings when installing8Install seal(s) in bearing housing: If installing two back-to-back seals use ONIC Seal Installer,
PIN 326551Apply 0Nk: Gasket Sealing Compoundto the metal casing of the seals before installingInstall the inner seal with
lip facing toward the bearing housing and install the outer seal with lip facing away from the bearing housingApply 0Nk:
Triple-Guard grease to the seal lips after installing If installing an extended-lip seal, use 0Nk: Seal Installer PIN 342665Apply
oil to the casing of the seal before installingInstall the seal with the exposed lip facing away from the bearing housingPress