1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 261Get this manual

1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 261

16If necessary, tie knot in one end ofthe starter ropeWith the starter housing upside down on bench, wind the pulley counterclockwise
washer to the starter housingPlace the thin washer under head of the screwInstallation 19Install the starter lockout lever
1Position the starter assembly onto the motorPlace the lifting ring on the rear screw mounting bossInstall the five starter
housing retaining screwsBe sure to place washers between the starter housing rubber mounts and the motorTighten the three
starter housing screws to torque of 120-144 inIbs(14-16 Nm) 2Tighten the two starter handle bracket screws to torque of 60-84
inIbs(7-9 Nm)3Apply OMC Triple-Guard grease or Lubriplate 777 to the starter lockout slide area of the starter housingPlace
the starter lockout slide in the channel of the starter housingLoosely secure the starter lockout cable to the starter housing
with cable clamp and screw 4Shift the motor to NEUTRAL positionAdjust starter lockout cable so that starter lockout slide
is centered on the lockout lever Tighten the cable clamp screw securelyCheck operation of the starter lockoutManual starter