1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 277Get this manual

1996 Johnson Evinrude "ED" 40 thru 55 2-Cylinder Service Manual, P/N 507124, Page 277

[] 4Remove pinion and base [IJ INote Before disassembly, scribe caps for reference during reassembly marks on frame and
of the windings 4Check permanent magnetsMagnets should attract steel or iron objects held inside the frameWeak magnets will
cause excessive RPM on No Load Current Draw, Electric Starter test5Do not clean drive assembly while the starter and drive
are installedThe cleaning agent could drain into the starter, washing dirt from the drive into the bearings and commutatorAfter
disassembling, clean each part with grease solvent and inspect 6If the pinion does not properly engage the flywheelthe pinion
and screw shaft assembly may be worn, distorted, or dirtyLocate the cause and correct before completing assembly38289 Assembly
1Lubricate the armature shaft bearing surface with one drop of SAE No.1 oilLubricate pinion helix on armature shaft with