1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 43Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 43

Rigging Information To prevent accidental starting of engine, verify that battery cables are disconnected at batteryControl
RUN position4While rotating the propeller shaft, move the remote control handle from NEUTRAL to the FORWARD detent and then
halfway back to NEUTRALThis positions the control for proper throttle cable adjustment INote Failure to follow this procedure
exactly might cause accel- erated wear of shift system components and high shifting effort5Remove the timing sensor coverBe
sure the timer base lever is against stop on the flywheel cover rn In 6and washer supplied guide enginelever pin using Attach
cable casing to throttle cotter clip with [] 7Pull lightly on throttle cable to remove backlash and install trunnion nut
in anchor pocket8Temporarily install cable retainer9Check cable adjustment; if throttle cable adjustment is too loose, idle