1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 62Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 62

6Test the "NO OIL" warning circuit: Connect shop tank with 50: fueloil mix to the fuel inlet fitting Remove the protective
be in the line Install the oil hose on the oil inlet fittingUse only the clamp supplied with the kit to secure the line To
complete priming, squeeze the oil primer bulb until oil is visible at the sight tube located in the oil hose near the VRO$
pump During the break-in period, the engine's fuel tank must have 50: fueloil mixture in addition to operation INote Prime
the oil system before priming fuel systemIf fuel system is primed first, the oil system must be primed with the engine idlingPrime
until oil is visible at the sight tubeWarning horn will sound until oil reaches the pump8Store the protective cap removed
from the oil inlet fitting on the yellow cap holder attached to the VRO fuel hose9The oil level must be marked on the side
of the reservoir before putting the engine into service After the break-in period, the operator must verify that oil has
been used before switching to clear fuel in the boat's fuel tank10Follow Engine Break-In Procedure outlined in Section 1E