1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 65Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 65

INote Push fuel hose off fuel fittingsdon't pullIf pushing won't separate hose and fitting, carefully cut the hose along
its level is even with the highest mark6Start the engine, and monitor the pump cycles by using fuel pressure gauge or by
putting light finger pressure on the outlet hoseThroughout the RPM range, the oil level in your hose should drop inches (76
mm) between to pulses7If your results vary, check the pulse limiter fitting before replacing the pump 8If you remove the
pump, carefully cut the hose to avoid damaging the fittingWhen installing, use ratchet clamp on the oil supply hoseTorque
the screws, pump-to-bracket, to 18-24 inIbs(2-3 Nm)Refer to Hose Routing Chart, this section INote When installing the oil