1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 125Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 125

STEPPOWER COIL TEST Ground Test 1Disconnect the starboard side Packard connector between stator and power pack2Attach test
3Crank engine and observe meterIf meter shows 50 volts or higher, proceed to next step indicated in Troubleshooting Sequence
Chart, Page 3-24 If meter shows less than 50 volts, check condition of wiring and connectors If wiring and connector condition
is good, go to Ohmmeter Test Ohmmeter Test INote All ohmmeter tests must be performed with engine NOT running1Calibrate ohmmeter
on appropriate scale rn 2Connect meter between orange and orangeblack stator leads: Meter must show 55 10 ohms 3To test for
grounded condition, connect ohmmeter black lead to clean engine groundAlternately connect ohmmeter red lead between orange,
orangeblack leads: Any needle movement indicates power coil or leads are grounded Locate and repair ground, or replace stator