1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 147Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 147

6Thoroughly wash entire cylinder block and crankcase with warm, soapy water to remove all traces of contaminants7Air dry
3Check for cylinder head warpage using piece of bar stock or machinist's straightedge and feeler gauge set Cylinder head
warpage must not exceed 0.004 in(0,10 mm) end to endResurface or replace head if warpage exceeds this dimension 4Use micrometer
to measure the diameter of each crankpin and main bearing journalThe lower main bearing journal would only be measured if
the bearing was removed for another reasonRefer to Engine Specifications, Section 1, for dimensions 5Visually inspect crankcase
seal rings for worn, grooved, or chipped conditionIf they appear worn, use micrometer to measure their thickness Replace
any ring that is less than 0.154 in(3,9 mm) thickInstall seal rings in their original positions on crankshaft after inspectioninspect