1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 149Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 149

1 19l 13Inspect center main bearing and split sleeves for excess wear, nicks or scratchesReplace if necessaryi.iQl 14Inspect
PI 338647, and drive the f21 2Oil the end of the crankshaftPlace new sleeve in sleeve onto the crankshaft until the installer
contacts the lower main bearing If the installer sticks on the sleeve after installation, thread OMC Slide Hammer, PI 391008,
into installer and pull offInspect sleeve surface after installing Sleeve must not be used if surface is damagedfJl 3Lubricate
new driveshaft a-ring and lightly lubricate crankshaft splines with OMC Moly LubeInstall a-ring in sleevefJl 4Using external
retaining ring pliers, install bearing retaining ring with sharp edge facing away from bearing 5Lubricate the center main
bearings and split sleeves with Evinrude or Johnson Outboard Lubricant and install them in their original positionsThe split