1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 151Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 151

14 35264 14Using avIC Cone, PI 318600, and Driver, PI 318599, install new wrist pin retaining rings in each wrist pin holeGap
is facing up and horizontal to the floor 18Coat pistons, rings, cylinder walls, and avIC Ring Compressor, PIN 336314 (PI
336313 for oversize pistons), with Evinrude or Johnson Outboard Lubricant19Center connecting rod in piston and locate piston
rings on dowel pinsSlide No.2 piston assembly into top cylinder while guiding connecting rod through cylinder block 20Repeat
Steps 18 and 19 for remaining pistons on port side 21Lightly lubricate new cylinder head a-rings with OMC Triple-Guard greaseInstall
a-rings in cylinder block [1ZJ 22Apply 'A6 in(2 mm) bead of RTVadhesive around each water passage on the cylinderDo not apply
adhesive around thermostat seat area Place new thermostat seal in cylinder head with side marked "TO CYL HEAD" facing out