1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 152Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 152

The port head has temperature switch with two wires, the starboard head has switch with one wire23Rotate cylinder block so
and install bearings r:m 29Lubricate threaded portion of No.1Align cap screws with rod Evinrude or Johnson Outboard Lubricantdot
on rod cap with dot on the connecting rodInstall rod cap screws finger tight INote Be sure alignment dot on rod cap matches
dot on rod and " that both dots face flywheel Torquing the screws without OMC Alignment Fixture, PIN 396749, or using an
incorrect procedure could cause permanent damage to the connecting rod and crankshaftTo maintain accurate torque values,
keep torque wrench extension length to minimum 1221 30Torque the rod cap screws using OMCRod Cap Aligning Fixture, PIN 396749Align
the flat marked "set" on the rod engagement stop with the arrow on the frameMove the adjustment knob to setting Rotate adjustment