1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 192Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 192

5Remove the large thrust washer reverse gear from the gearcase thrust bearingand 6V6Remove the small thrust washer from either
OMC Wrench Retainer, PI 341438 Q)Pad the handle of the holder to prevent damage to the gearcase[]]10Pull up on the driveshaft
to remove it from the gearcaseThe driveshaft to pinion taper is locking taperIf necessary, use a,nc Puller, PIN 390706and
a,nc Backing Plate, PIN 325867 (h), to break the lockInstall the tools as shown by clamping them around the driveshaftAlternately
tighten the two vertical screws against the backing plate inserted between the puller and the gearcase until the driveshaft