1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 194Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 194

Q)- 4 4513 4514 20Wrap the housing with shop clothRotate the detent lever 90 in either direction, then pull the detent lever
replaced, use OMC Bearing Remover and Installer, PIN 391257, and assemble it as follows: 14-20 112 inHex Head Screw inO.DFlat
Washer PIN 326582 Rod PIN 391260 Plate PIN 326574 Remover 14-20 114 inHex Head Screw Position the tool in the gearcaseUsing
mallet, drive the bearing from the gearcase Flange Nut, PIN 326586 Plate, PIN 391260 Rod, PIN 326582 Remover, PIN 326579
Make sure all 18 needle bearings are inside the bearing case before pulling the bearingThe needle bearings provide surface
for the remover to pull against Use Pis inwrench to hold the remover in placeUse 34 inwrench to turn the flange nut clockwiseDraw