1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 195Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 195

12411251 24Inspect the water intake screen for blockageRemove the screen by using one of the following methods: Depress tabs
the bearing housing O-ring(s)Clean the housing and bearings in solvent, and dry thoroughlyIf bearings were not replaced,
rotate the needles with your fingers to check for freedom of movementInspect O-ring groove, and sand off any sharp edges
that would cut O-ring and prevent its sealing 4Inspect the bearing housing anodeReplace anode if it has reduced to two-thirds
of its original size (one-third eroded)5Oil, then install new bearings in the bearing housing V4use OIVIC Bearing Installer,
PI 326562, to install the forward bearing and rear bearing V6use OIVIC Bearing Installer, PIN 339750, to install the forward
bearing and OIVIC Bearing Installer, PIN 340820, for the rear bearing Place the lettered end ofthe bearing case on the bearing