1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 196Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 196

6 DR2061DR2062 DRC5720 6V4Install seal(sl in bearing housing: []] If installing two back-to-back seals, use avIC Seal Installer,
the tool seatsApply OMC Triple-Guard grease to the seal lips after installing141 55 [] 8Lightly apply avIC Triple-Guard grease
to new bearing housing O-ring(slInstall the O-ring(sl in its groove in the housingDriveshaft Bearing Housing Service The
driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft
bearing surface if the bearing is damaged[] 1Remove the two driveshaft bearing housing seals using avIC Puller Bridge, PI
432127, and OMC Large Puller Jaws, PIN 432129Discard the seals2Remove the O-ring from the bearing housing and discard3Clea
the bearing housing in solvent to remove sealer from the seal bo re and the O-ring groove DRC5721 4Install new seal in the
bearing housing using OMC Seal Installer, PI 341439Apply oil to the casing of the seal before installingInstall the seal