1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 202Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 202

COA3168 20Move shift rod from side to side while pushing on the propeller shaft to ensure proper alignment of the bearing
bearing housing onto the driveshaft25Pull up on the shift rod to engage FORWARD gearTurn the gearcase upside down by rotating
the holding fixtureBe sure any excess grease is removed from the pinion needle bearingsDegrease inside taper of the pinionPosition
the pinion in the gearcase26Degrease the driveshaft taper and install the driveshaftTurn the gearcase right side up COA3130
27Lightly coat the threads of the pinion nut with outboard lubricant and install on the driveshaft using OMC Pinion Nut Starting
Tool, PI 342216Turn the driveshaft by hand to engage the nutRemove the pinion nut starting tool before applying torque to
pinion nut28Using OMC Driveshaft Holding Socket, PI 331875, OMC Pinion Holder PIN 334455, and OMC Wrench Retainer, PIN 341438,