1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 203Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 203

1241 29Position the washers on the driveshaft bearing housing screwsApply ONIC Gasket Sealing Compound to the threads of
holes in vertical position and anode facing downPress the bearing housing into the gearcase and tap the housing with soft
face mallet to seat the a-ring 1281 33Install the two retainers, washers, and screwsApply OMC Ultra Lock-271 to threads of
the two retainer screwsInstall the screws and torque them to 24-26 ftIbs(33-35 Nm)1291 34Before installing lubricant, pressure
test and vacuum test the gearcase as follows: Remove the oil level plug, and screw in pressure test gauge Pump up pressure
to 3-6 PSI (21-42 kPa)If pressure gauge indicates leakage, submerge the gearcase in water to determine source of leakage
as evidenced by bubblesIf the gearcase pressure gauge does not indicate leakage, increase pressure to 16-18 PSI (110-124