1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 217Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 217

5Rotate the driveshaft several revolutions to seat bearings [11J 6Lay the tool base on its sidePosition the correct shim
between the gauge bar and the pinionReplace the pinion or the driveshaft, as necessary, and repeat the check if variance
exceeds 0.002 in(0,050 mm)9Subtract the average clearance measurement you obtained in Step from 0.020 in(0,508 mm) to determine
the correct shim thickness requiredSelect the fewest number of shims to achieve the correct thickness10Remove the driveshaft
from the tool baseRemove the collar and bearing housing from the driveshaft, and add the required amount of shims Use extreme
care when removing bearing housing to avoid damaging the sealsUse OMC Driveshaft Seal Protector, PIN 318674 11Check shimming