1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 223Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 223

33Lightly apply OMC Triple-Guard grease to new O-rings, and install them on the bearing housingCarefully apply OMC Gasket
PSI (21 -42 kPa)If pressure gauge ind icates leakage, submerge the gearcase in water to determine source of leakage as evidenced
by bubblesIf the gearcase pressure gauge does not indi cate leakage, increase pressure to 16-18 PSI (110-124 kPa) If pressure
does not hold, submerge the gearcase in water and check for source of leakageMake necessary repairs and repeat test Screw
in vacuum testerPump out to 3-5 in(76-127 mm) of mercury and see if vacuum holdsThen, pump out to 15 in(381 mm) of mercury
and check If the gearcase fa ils to hold on either test, put oil around suspected sealIf leak then stops or oil is drawn
in, that seal is defectiveWhen the gearcase checks OK, refill with the proper lubricant Fill the gearcase with lubricant
as follows: Secure the gearcase in an upright position Remove the oil level plug and the drainfill plugReplace their seals,