1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 230Get this manual

1996 Johnson Evinrude "ED" 60 LV 90, 115, 150, 150C, 175 Service Manual, P/N 507127, Page 230

19Remove retaining ring if requiredDiscard retaining 20To assemble bearings to driveshaft, install new retaining ring (if
the lower bearing22Using retaining ring pliers, install retaining ring with sharp edge facing outMake sure the retaining
ring is seated in its groove in the driveshaftWear safety glasses and proceed with care to avoid unsnapping the ring from
the pliers ITID 23[!ID Install thrust washer against upper bearing with dished center section facing upwardPlace upper seal
carrier assembly onto the driveshaftApply OMC Triple-Guard grease to two new O-rings and install on upper seal carrier24Fill
bearing housing cavity with OMC Marine Wheel Bearing Grease 120 25Heat the bearing housing slightly with propane torch Press