1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 51Get this manual

1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 51

Rigging Information & To prevent accidental starting of engine, verify that battery cables are disconnected at batteryControl
Cable9.915 1Remove the rubber grommet from front of lower engine coverRemove cable retainerApply liberal amount of OMC Trip
leGuard grease to both anchor block pocketsgrease 2Extend throttle cable and lubricate with OMC Triple-Guard 3Move the remote
control handle to NEUTRALVerify that the fast idle lever is down in the RUN position4Attach cable casing guide to throttle
lever using clevis pin and cotter pin supplied with engineSecure cable by spreading cotter pin ends5Hold throttle lever tight
against idle stop screw6Pull firmly on throttle cable to remove backlash and install trunnion nut in anchor pocket7Install
cable retainer and torque screw to 60-84 in Ibs(7-9 Nm) 8Check cable adjustment: If throttle cable adjustment is too loose,