1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 79Get this manual

1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 79

m Assembly INote Before proceeding, be sure that all parts are perfectly cleanBe sure that all replacement parts match original
indicated "9.915 HP Be certain gauge is not holding down the float If float level is not between the notches of gauge, lightly
bend metal float arm to adjust levelBe careful not to force float needle valve into seat 6Check for correct float drop dimensionThis
dimension affects the full opening of the inlet needle and is critical to correct operation of the carburetorWith carburetor
body in normal running position, the float must drop open to dimension shownTo adjust, bend tab on float arm where tab contacts
float seat Q) Base of carburetor body Bend float lever tab to achieve proper dimension CD into 13s in(25-35 mm) 7Place the
lower gasket into the float chamberInstall the float chamber and bowl gasketTighten the screws to torque of 8-10 inIbs(0,8-1,2
Nm), following sequence embossed on float chamber8Install the carburetor body cover and gasketTighten the screws to torque