1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 117Get this manual

1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 117

Ignition Plate Servicing20 thru 30 Removal 1To avoid accidental starting of engine while servicing, twist and remove all
Place the spacer ring on the crankcase bosses [!] 2Lubricate the top side and underside of stepped washer, with OMC Moly
Lube, where it contacts the retainer and pilot ringPosition the stepped washer and pilot ring on the retainer[[] 3Install
the four screws to retain the pilot ringTorque to 48-60 inIbs(5-7 Nm) 4Lubricate the thrust washer with OMC Moly Lube and
place in ignition plate []] 5Apply OMC Nut Lock to ignition plate screwsLower ignition plate onto retainer and torque screws
to 25-40 inIbs(2,8-4,0 Nm) 6Check for sufficient slack on ignition component leads during full advance movement of the ignition