1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 128Get this manual

1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 128

11 DR4621 STEPSENSOR COIL TEST Ground Test [!!J 1Disconnect 5-pin Amphenol connector between ignition plate and power pack2Set
Locate and repair ground, or replace sensor coil4If no reading is indicated in Step 3, go to Output TestOutput Test 1Set
peak-reading voltmeter to: 9.915"NEG" and "50", or "SEN" and "50" on Stevens CD-77 meter 20 thru 30"pas" and "50", or "SEN"
and "50" on Stevens CD-77 meterr:J2l 2Attach voltmeter black lead to ignition plate connector, terminal "C"Attach meter red
lead to terminal "B"3Crank engine and observe meter If meter shows 1.5 volts or higher, go to STEPPOWER PACK TEST If meter