1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 131Get this manual

1996 Johnson Evinrude "ED" 9.9 thru 30 2-Cylinder Service Manual, P/N 507122, Page 131

STEPRUNNING OUTPUT TEST 1Twist and remove primary leads from ignition coilsf161 2.atwist to install Stevens Instrument NoTS-77
to clean engme ground5Adjust voltmeter to setting listed in following chartStart engine and run it under load at RPM where
ignition problem existsMeter must show at least: 9.915 20 thru 30 6Repeat Step for No.2 ignition coil Voltmeter "NEG", 500
"POS", 500 If either cylinder shows less than specified output, test charge coilRefer to STEPCHARGE COIL TEST charge coil
tests good, replace the power pack7Remove terminal extendersInstall ignition coil primary leadsObserve proper wire routingOrangeblue