2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 103Get this manual

2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 103

FLUSHING AND STORAGE COOLING SYSTEM FLUSHING Secure the watercraft stand or trailer and check that the stern is not higher
run the engine without cooling water supply for more than 15 seconds to prevent severe engine and exhaust damageIf the engine
stops 3Make sure the water flows out of the pilot water during this proceholedimmediately Let the engine idle for about 10
minutes while turn off the water, the water continues to flowIf water does not flow out of the pilot water hole, and resume
the workfromstep2 immediately turn off the water and then the engineThen, troubleshoot for possible problems4Turn off the