2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 169Get this manual

2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 169

FUEL SYSTEM (Programmed Fuel Injection) DTC 18-1 (CMP SENSOR) Before starting the troubleshooting, check the CMP sensor connector
Is the voltage more than 0.7 V? - Replace the ECM with known good one, and recheck - GO TO STEP 2 PEAK VOLTAGE ADAPTOR ECM
33P (Gray) CONNECTOR (Wire sidelfemale terminal) 2CMP sensor Peak Voltage Inspection 2 Pull the safety lanyard lock clip
off of the engine sto switchisc connect the CMP sensor 2P (Black) connectorInsert the safety lanyard lock clip in engine
stop switchCrank the engine with the starter motor, and measure the CMP sensor peak voltage at the CMP sensor connector terminals
of the sensor sideConnection: Bluelyellow (+)Green (-1 Is the voltage more than 0.7 V? CMP SENSOR 2P (Black) CONNECTOR (Sensor