2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 196Get this manual

2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 196

FUEL SYSTEM (Programmed Fuel Injection) Connect the voltmeter to the wire harness side connector terminalsConnection: Blacklbrown
using the special tool TOOL: Fuel sender wrench 07XAA-001010A or 07AAA-SOXA100 (U.S.Aonly) Remove the lock nut and fuel pump
assembly from the fuel tank, being careful not to bend the float rodRemove the base packing from the fuel pump INSPECTION
Do not disassemble the fuel pump unless the strainer cleaning is necessary as the pump must be replaced as an assemblyDisconnect
the fuel level sensor connector from the fuel pump unitRelease the fuel level sensor unitPull the fuel pump from the pump
reservoirCheck the fuel pump unit from for wear or damage, replace it if necessaryClean the fuel strainer screen with non-flammable
or high flash point solventCoat the O-ring Assembly is in the reverse order of disassemblywith engine oil and install it