2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 243Get this manual

2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 243

ENGINE REMOVALIINSTALLATION ENGINE-TO-JET PUMP ALIGNMENT Loosen all the engine mounting boltsLift the engine slightly and
two lower mounting bolts, and the center support into the setting plate with the dowel pins and four socket bolts (including
special tool) as shownTighten all the bolts securelyLoosen the mounting nuts of the bearing housing before installing the
alignment shaft SPECIAL WASHERS Insert the alignment shaft into the bearing housing through the center support while turning
it slowly, being careful not to damage the seals in the bearing housing Do not damage the Install the coupler attachment
over the alignment drivecouplerwhen shaft and attach the coupler attachment onto the installing the drive coupler by pushing
the alignment shaftcoupler attachment Tighten the bearing housing mounting nutsover it BEARING HOUSING COUPLER ATTACHMENT