2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 298Get this manual

2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 298

CRANKSHAFTIBALANCERIPISTON REMOVAL Mark the bearing caps and bearings as you remove them to indicate the correct cylinder
the bearing cap is hard to remove BEARING CAPS Before removed, position all the pistons at TDC (Top Dead Center) to prevent
connecting rod from damaging the crankpin with the connecting rod bolt threadsRemove the crankshaft and the cam chain INSPECTION
Hold both ends of the crankshaftSet dial gauge on the center main journal of the crankshaftRotate the crankshaft two revolutions