2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 353Get this manual

2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 353

PROPULSION SYSTEM BEARING HOUSING INSTALLATION Install the housing boot band over the boot band base by aligning the band
using the special tools as follows BEARING HOUSING TOOLS: Alignment tool setstopper collar (not used)stopper collar (not
used)setting platecenter support and shaftcoupler attachment (not used) 070MJ-HWIA101 070MJ-HWlA140 07AMJ-HW5A130 070MJ-HWlA130
070MJ-HWlA120 070MJ-HWIA110 Install the two dowel pins into the thrust plateInstall the setting plate onto the thrust plate
with the jet pump mounting bolts, adding the two special washers from the Stopper collar set on the lower mounting bolts,
and the center support into the setting plate with the dowel pins and four socket bolts (including special tool) as shownTighten
all the bolts securelyInsert the alignment shaft into the bearing housing through the center support while turning it slowly,