2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 371Get this manual

2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 371

STEERINGREVERSE SYSTEM Make sure to set the switch lever onto the guide rail of the cable arm properlyApply locking agent
lever sliding area (guide rail)Make sure the steering shaft moves smoothly, without play or bindingPlace the handlebar onto
the holders of the steering shaft while inserting the handlebar switch wire into the steering shaft and align the punch mark
on the handlebar with the left holderInstall the handlebar holders and bolts with the punch marks on the holders facing upTighten
the upper bolts first, then tighten the lower bolts CABLE ARM TORQUE: 22 N-m (2.2 kgfmm, Ibf-ft) 16 Insert the wire of the
warning buzzer into the steering shaft Route the throttle Set the wire boot onto the wires of the handlebar cableproperly
switch and buzzer, and insert the throttle cable into (page 1-79) the boot and the steering shaft as shown To steering shaft