2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 395Get this manual

2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 395

IGNITION SYSTEM Connect the peak voltage tester or peak voltage adaptor probes to the wire harness side connector terminals
terminal) Disconnect the CKP sensor 5P (Black) connector and connect the peak voltage tester or adaptor probes to the connector
terminals of the CKP sensor sideIn the same manner as at the ECM connector, measure the peak voltage and compare it to the
voltage measured at the ECM connectorIf the peak voltage measured at the ECM is abnormal and the one measured at the CKP
sensor is normal, the wire harness has an open or short circuit, or loose connectionIf both peak voltages are abnormal, check