1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 50Get this manual

1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 50

MAINTENANCETUNE UP Lubrication Drive Shaft Lubrication WARNING The plastic driveshaft shroud is designed to protect you from
Driveshaft Coupler (Solid) 4Turn driveshaft coupler until grease fitting is accessibleUsing grease gun with needle point,
lubricate coupler at grease fitting until coupler boot just begins to expand5Reposition driveshaft shroud (open side down)
and torque clamp screw to 25 inIbs6Reconnect battery ground (negative) cable7Reinstall seatModels With Bonded Rubber Coupler
(1996-Current) Driveshaft splines should be lubricated during pre season maintenance, every 100 hours, or when pump is disassembledSealing
O-rings at impeller end and inside coupler should be inspected and replaced if worn or damagedRefer to Final Drive section
for driveshaft removal procedureUse Premium All Season GreaseBonded Rubber Coupler Lubricate O-ring and Splines Forward Bearing