1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 384Get this manual

1992-1998 Polaris Personal Watercraft Service Manual PN 9912201, Page 384

FINAL DRIVEJET PUMPBILGE SYSTEM Pump Drive Shaft Alignment (All Models) The drive shaft must be properly aligned to prevent
this section)Remove bearing housing from through-hull fittingRemove tail coneRemove impeller and stub shaft from pump housingInspect
bearings for wear or damage and replace if necessarySee Pump DisassemblyInspection this sectionAssemble pump without stub
shaft, impeller, or tail coneInstall pump assembly to hull (1992 and 1993 models) or stator housing to pump housing (1994
to current) Tighten mounting nuts to 28 ftIbs(3.86 kg-m) (1992 and 1993 models) or mounting bolts to 18 ftIbs(2.48 kg-m)
(1994 and 1995 models) Install alignment tool into pump bearing housing with the smaller diameter coupler end facing toward
engineSlide coupler end of alignment tool into drive couplerWatercraft EnginePump Alignment Tool PN 2871343 10If engine and
pump are properly aligned, the tool will slide freely into the engine coupler11If mis-alignment is evident, determine the
probable cause of misalignment from the following chart and correct the condition Coupler end small diameter Pump endlarge